December/2019 Braindump2go 300-070 Exam Dumps with PDF and VCE New Updated Today! Following are some new 300-070 Exam Questions,
What is required to configure NTP on a Cisco Unified Communications Manager publisher to support SIP phones?
A. Configure the NTP server in Cisco Unified CM Administration
B. Configure Phone NTP References in Cisco Unified CM Administration
C. Configure the NTP server in Cisco Unified OS Administration
D. Restart the Unified Communications Manager services for the publisher and subscribers on the Unified CallManager serviceability page.
Which digit manipulation command works under a VoIP dial peer?
Which feature allows TelePresence endpoints to have a multipoint video conference without using MCU resources?
A. Media Termination Point
D. Conference Bridge
When using video in the Cisco Unified Border Element, which RTP flow offers no protection from the address hiding perspective?
A. Early offer
B. Delayed offer
According to the DiffServ architecture RFC 2475, which two major components are necessary to deliver end to-end QoS? (Choose two)
A. Layer 2 transport QoS mechanisms such as FRF.12
B. packet marking with 6 bits to classify packets
C. ToS or IP precedence with 3 bits
How many TelePresence MCU conference bridges can be configured in one conference bridge pool in a TelePresence Conductor cluster?
You war to set up calls form endpoint s registered to Cisco Unified Connumerations Manager to video endpoints registered in VCS.
How do you set up the configuration in Cisco Unified CM?
A. Create a route pattern and assign the SIP trunk that points to the VCS.
B. Create a SIP route pattern as IP address routing with the VCS domain, and associate the SIP route pattern to the correspondent sip trunk that points to the VCS.
C. Create a SIP route pattern as domain routing with the VCs domain, and associate the SIP route pattern to the correspondent SIP trunk that points to the VCS.
D. Set up a SIP trunk.
Which two are characteristics of a Cisco Unified Communications Manager software based Media Termination Point? (Choose two)
A. This Media Termination Point type is typically used for RSVP agent configurations or Cisco Unified Border Element media flow-through configurations
B. The codec and packetization of both call legs must be identical
C. DSP resources are required
D. This Media Termination Point type does not require any DSP resources on the Cisco router
E. It can provide G.711 mu-law to G.711 a-law conversion and vice versa.
An engineer has hundreds of H.323 gateways with thousands of route patterns in a Cisco Unified Communications Manager cluster. The engineer has noticed may specific route patterns created to the H.323 gateways.
Which digit manipulation method on route patterns is most effective in reducing the number of route patterns?
A. regular expressions
B. discard digits
C. prefix digits
D. called-party transform mask
Which two CLI commands allow you to verify the correct VolP dial-peer matching? (Choose two)
A. debug voip dialpeer inout
B. show dialplan number
C. debug dialpeer match
D. debug ccsip messages
E. debug voip ccapi service
How does Cisco Unified Cisco Unified Communications Manager perform digit analysis?
A. Perform a digit-by-digit analysis to find the best matching route pattern within the partition list in the calling search space of a device
B. Use a set of route lists and filters to match all collected digits of a dialed number.
C. Perform a digit-by-digit analysis to find the best matching route pattern based on a devices partition
D. Send all collected digits through the Dialed Number Analyzer to determine the best call routing match within Cisco Unified CM
1.|2019 Latest Braindump2go 300-070 Exam Dumps (VCE & PDF) Instant Download:
2.|2019 Latest Braindump2go 300-070 Exam Questions & Answers Instant Download: